I use the BAL leveler even when connected if its not close to level. I will disconnect the umbilical

Some doz and dozn't. I do at times. If I'm just sleeping like in a rest area I leave the truck and trailer connected. In a campground I usually disconnect the trailer. It's easier to access the stuff in the back of the truck with the tongue out of the way.
The deploy the stabilizers on the rear making sure each stabilizer's foot is in contact with ground, or pad surface. Back to the front and raise the tongue with the tongue jack until the trailer is level.
A level trailer becomes important when you're using the refrigerator , most RV fridges want to be level. Once level I light the fridge and pull out a chair, discount hotels atlanta relax an look around discount hotels atlanta at what ever there is to see from the comforts of my camping chair.
Thanx all..i did bring a jack for the back on one side and a plastic milk crate for the other ..also have the front jack down so super stable at present..will take a few pics in morning..happy holidays all
Last weekend I think I this was the problem. I was hooked up most of the weekend and didnt unhook the the 7pin connector and when I went to start my Rav4 I need a jump...been fine since. The battery is 5yo but they usually discount hotels atlanta go for 6 before dying.
I often times stay connected if I dont have to drive anywhere and not told I have to disconect...mostly out of lazyness lol. I still have yet to use the rear stabilizers. When I do disconect, I have 2 jackstands I put out under the frame near the tongue so the tongue jack isnt supporting all the weight . Seems stable to me. I am guessing that since the large dinette is down full time and I am sleeping really close to the axle Im not putting enough weigh farther back to lift the tongue. Had that happen once with my lil home built gypsy vardo though lol
My 19' scamp will get light in the back with 40 gallons freshwater and a person or two in the back. I just use regular jackstands for now. I'm going to put a bal dual rear stabilizer setup on it, but I'm waiting until I get the doubled up frame rail under the back.
We stay connected to the trailer on occasion. Though our tow vehicle charge wire, like Floyd's, has a switch in series, we always disconnect the 7 pin connector. As well we put the trailer jack down.
In my opinion even though you're still hooked up you should check your trailer connections before hitting the road again. We go through our traditional series of checks whether we stay connected to the tow vehicle or not.
Unless I'm planning to use the tow vehicle to get somewhere discount hotels atlanta else while stopped, or need to unhook to level the trailer, I rarely discount hotels atlanta unhook discount hotels atlanta for one night stops. I do have a disconnect relay between the vehicle trailer...
I use the BAL leveler even when connected if its not close to level. I will disconnect the umbilical cord though from now on. I was running discount hotels atlanta my fantastic fan nonstop so it must have been pulling from my TV battery